User manual

17
Chapter 2
Setting up the RaQ 3
This chapter guides you through the process of connecting and
configuring the RaQ 3 for your network. A typical setup process takes
less than 15 minutes, after which you can begin setting up web sites and
using other RaQ 3 services.
If the RaQ 3 has been previously configured for a different network,
refer to “Changing network configuration” in Appendix A.
The setup process consists of two phases.
• “Phase 1: Making the connection” covers the physical setup and
connection of the RaQ 3 to a power source and the network.
• “Phase 2: Setting up with the Web browser” covers the network
integration process and allows the administrator to select services
and create users and groups, using any browser-enabled computer.
Phase 1: Making the connection
Installing the RaQ 3
The RaQ 3 can either be placed on a flat surface — for example, a desk,
shelf or table top — or it can be connected to a standard 19-inch
equipment rack.
!
Caution: If you operate the RaQ 3 in an equipment rack, see
the precautions described in “6. Operating the unit in an
equipment rack” on page iv.