User manual

Chapter 2: Setting up the Qube 3
12 Cobalt Qube 3 User Manual
Figure 6. Network connectors
Connecting the power supply
There are two parts to the power supply: the power supply unit and the
country-specific AC power cord.
Connect the power supply unit to the Qube 3 by pushing the connector into the
multiple-source DC power socket; see Figure 6. Plug one end of the AC power
cord into the power supply unit and the other end into an electrical outlet.
Powering on the Qube 3
Turn on the power by pressing the On/Off switch on the back of the Qube 3; see
Figure 1 on page 2.
The hard disk spins up and the fan turns on. The light bar on the front of the unit
blinks a few times and then glows steadily.
A number of status messages are displayed on the LCD screen as the Qube 3
completes its boot process.
!
Caution : It is important to follow the proper power-down procedure
before turning off the Qube 3. Refer to “Power down” on page 203.
Primary
network
interface
Secondary
network
interface
Serial
port
Power
socket