User manual

Advanced network
Cobalt Qube 3 User Manual 199
DHCP primary
To configure the primary network interface on the Qube 3 using a DHCP server:
1. On the LCD console, hold down the button for approximately two
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button until ADVANCED NETWORK appears in the LCD
screen:
SELECT:
ADVANCED NETWORK
3. Press the button. The LCD screen displays:
SELECT:
REVIEW SETTINGS
4. Press the button until DHCP PRIMARY appears in the LCD screen:
SELECT:
DHCP PRIMARY
5. Press the button. The Qube 3 looks for a DHCP server on the network.
If it finds a DHCP server, the Qube 3 resets its primary network interface
with information received from the DHCP server. The Qube 3 also resets its
default gateway, host name and domain name, if it receives this information.
If the Qube 3 obtains IP addresses for DNS servers, those IP addresses are
appended to the list of DNS servers.
The LCD screen displays the fully qualified domain name on the top line and
the IP address on the bottom line.