User manual

System

Cobalt Qube 3 User Manual 165

4. Click Add. The Add Static Route table appears; see Figure 82.

Figure 82. Add Static Route table

5. Conﬁgure the Add Static Routes table ﬁelds:

• Target Subnet. Enter the IP address of the subnet to be re-routed. Enter

a series of four numbers between 0 and 255 separated by periods. For

example, 192.168.1.0 is a valid entry.

• Target Network Mask. Enter the network mask of the subnet to be re-

routed. Enter a series of four numbers between 0 and 255 separated by

periods. For example, 255.255.255.0 is a valid entry.

• Gateway. Enter the IP address of the network gateway through which

the target subnet's packets will be re-routed. Enter a series of four

numbers between 0 and 255 separated by periods. For example,

192.168.1.1 is a valid entry.

• Network Interface. Select the network interface through which the

target subnet’s packets will be re-routed. If no device is specified, a

device will be selected based on the IP address of the network gateway.

Your choices are:

• Primary Ethernet Interface

• Secondary Ethernet Interface

• Point-to-Point Protocol Interface

6. Click Save.

Internet

The following sections describe how to conﬁgure a connection to the Internet

through the Qube 3. The Qube offers three connection methods:

• Gateway on local area network (LAN)

• Cable modem or Digital Subscriber Line (DSL)

• Analog modem or Integrated Services Digital Network (ISDN) terminal

adapter