User manual

Chapter 5: Administration Site

162 Cobalt Qube 3 User Manual

2. Select one of the following telnet access options to specify who has telnet

access to the Qube 3.

• Off - Do Not Allow Logins. No telnet access is available. This is the

most secure option for the Qube 3.

• On - Allow Only Administrator Logins. Only the Qube 3

Administrator can telnet into the Qube 3.

• On - Allow All User Logins. The Qube 3 Administrator and all

registered users can telnet into the Qube 3. This is the least secure option

but provides the most flexibility.

3. Click Save.

System

This section describes how to use the following system administration screens:

• TCP/IP. Configure the TCP/IP settings.

• Internet. Configure settings specific to the type of internet connection

for gateway on a LAN, cable modem or DSL, or analog modems and

ISDN terminal adapters.

• Power. Reboot the Qube 3.

• Time. Set the Qube 3 time settings.

• Information. Display information about the Qube 3.

TCP/IP

To conﬁgure the Transmission Control Protocol/Internet Protocol (TCP/IP)

settings for the Qube 3:

1. Select Administration > System > TCP/IP. The TCP/IP Settings table

appears; see Figure 80.

✍-

Note: The second and third options pose security risks; however,

they allow the user to conﬁgure options supported by the Linux

operating system that cannot be conﬁgured through the Web-based

Server Desktop interface.