User manual

Chapter 5: Administration Site
148 Cobalt Qube 3 User Manual
4. Click Add for the Dynamic Address Assignments List to open the table
shown Figure 69.
Figure 69. Add New Dynamic Address Assignment table
5. Specify the following settings:
• IP Address Range (From). Enter the first or lowest IP address in the
range of IP addresses to be dynamically assigned by this server. Enter a
series of four numbers between 0 and 255 separated by periods. For
example, 192.168.1.100 is a valid entry.
• IP Address Range (To). Enter the last or highest IP address in the range
of IP addresses to be dynamically assigned by this server. Enter a series
of four numbers between 0 and 255 separated by periods. For example,
192.168.1.110 is a valid entry.
6. Click Save .
7. Click Add for the Static Address Assignments List to open the table shown
in Figure 70.
Figure 70. Add New Static Address Assignment table
8. Specify the following settings:
• IP Address. Enter the IP address to be statically assigned by this server
to a specific computer; the computer is identified by its Media Access
Control (MAC) address entered in the second field.
• MAC Address. Enter the MAC address of the computer that receives a
static IP address from this DHCP server. A MAC address is the hardware
address of the network interface card. This hardware address is a unique
identifier and cannot be changed after manufacture.
Enter a series of 12 hexadecimal digits separated by a colon between
every 2 digits. For example, 00:10:E0:01:33:AB is a valid entry.
9. Click Save .