User manual

iv
Power Cord
!
Caution: The power supply cord is used as the main disconnect
device. Ensure that the socket-outlet is located/installed near the
equipment and is easily accessible.
!
Attention:Le cordon d’alimentation est utilisé comme interrupteur
général. La prise de courant doit etre située or installée a proximité du
matérial et etre facile d’accés.
!
Achtung: Zur sicheren Trennung des Gerates vom Netz ist der
Netzstecker zu ziehen. Vergewissern Sie sich, daß die Steckdose leicht
zuganglich ist.
Electrical Shock
To reduce the risk of electrical shock, do not disassemble this product. Opening or
removing covers may expose you to dangerous voltage and incorrect reassembly can cause
electrical shock. This product should be serviced by a qualiÞed technician.
Using Equipment Racks
If you plan to operate the Cobalt NASRaQ in an equipment rack, take the following
precautions:
¥ Verify the ambient temperature around the Cobalt NASRaQ (which may be
higher than the room temperature) is within the limits speciÞed in ÒPhysical
DataÓ on page 46.
¥ Ensure there is sufÞcient air ßow around the unit
¥ Check that electrical circuits are not overloaded Ñ consider the nameplate
ratings of all the connected equipment, and make sure there is over current
protection.
¥ Check that equipment is properly grounded Ñ particularly any equipment
connected to a power strip.
¥ Do not place any objects on top of the Cobalt NASRaQ.
English
French
German