User manual

Setting Up the NASRaQ

2. Press .

If the IP address is valid, the prompt appears:

ENTER NETMASK:

255.000.000.000

3. Enter the netmask of your network, if the number shown is

not correct.

4. Press .

If the netmask is valid, the following prompt appears:

ENTER GATEWAY:

000.000.000.000

5. Enter the IP address of the gateway for your network.

If your network doesnÕt have a gateway, donÕt enter any

number Ñ leave the default value, Ò000.000.000.000.Ó

6. Press .

The LCD displays:

[S]AVE [C]ANCEL

7. To save the conÞguration information, use the Left and Right

buttons to select [S]ave, and then press . YouÕll see:

VERIFYING AND SAVING

Note: Selecting [C]ancel cancels the conﬁguration, and the

LCD screen displays ENTER IP ADDR: again. The NASRaQ

goes through the entry process again.

After verifying and saving, the NASRaQ completes the boot

process, and the LCD screen shows several messages before

displaying the IP address assigned to the NASRaQ.

ConÞguration is complete when the LCD screen displays the

NASRaQÕs assigned IP address, for example:

IP Address:

127.162.05.18