User manual

Chapter 2
12
Figure 4 Control buttons
HereÕs how the control buttons work:
The reset port is used to reset the NASRaQ.
The Left button moves the cursor left.
The Right button moves the cursor right.
The Up button increments the digit located at the
cursor position.
The Down button decrements the digit located at the
cursor position.
The S button (ÒselectÓ) selects the next option.
The E button (ÒenterÓ) accepts the information.
ÒUsing the LCD ConsoleÓ on page 41 gives additional
information about using the LCD Console.
To Manually Configure NASRaQ
During setup, the LCD console is used to enter network
conÞguration information on the NASRaQ.
Follow these steps to conÞgure the network manually:
1. When you see the prompt
ENTER IP ADDR:
000.000.000.000
Enter the IP address assigned to the NASRaQ using the LCD
control buttons.
LCD Screen Reset Port
Control Buttons
S
E