User manual

Setting Up the NASRaQ

Manual Conﬁguration using Control Buttons

If the NASRaQ doesnÕt Þnd a DHCP server on the network,

the following prompt appears on the LCD display:

ENTER IP ADDR:

000.000.000.000

If this prompt appears, you need to enter the required

network information using the LCD control buttons. See

ÒUsing the LCD ConsoleÓ on page 41.

Before you proceed, make sure you have the following

information:

¥ The NASRaQÕs assigned IP address

¥ The subnet mask of your network

¥ The gateway/router address (necessary only if

communicating with other networks or the Internet.)

Enter the NASRaQ IP address in the URL Þeld of your

browser, for example, http://192.168.25.77.

Using the LCD Console to Conﬁgure the Network

The NASRaQÕs LCD screen displays two lines of text (see

Figure 4). The top LCD line provides instructions on data to

enter. The bottom line displays the data already entered. Use

the control buttons to the right of the LCD screen to enter the

required network information.