User manual

Setting Up the NASRaQ
9
Connecting to the Network
Connect one end of a Category 5 Ethernet cable to the 10/100
Base-T network connector on the back of the NASRaQ (see
Figure 3). Connect the other end to an existing network
socket.
Figure 3 NASRaQ Rear View
Connecting the Power Cord
Connect the power supply cord to an electrical outlet (100-
240 volts AC, 50/60 Hz, as listed in ÒProduct SpeciÞcationsÓ
on page 45).
Powering On the NASRaQ
Turn on the power by pressing the On/Off switch on the back
of the NASRaQ.
The hard disk starts up, the fan turns on, and the LCD screen
lights up and displays the message
Starting Up
.
Status messages are displayed on the LCD screen as the
NASRaQ completes its boot process.
!
Caution: It’s important to follow the proper power-down
procedure before turning off the NASRaQ. Refer to “Powering
Down” on page 43.
Serial
100 - 240 VAC 50/60 Hz
1.0 A 40W max
Tx/Rx
Link
100 M
Col
OK to
Power Off
Cobalt Networks and Cobalt NASRaQ
are trademarks of Cobalt Networks, Inc.
Network 1
www.cobaltnet.com
SCSI
Network
Connector
Power
Socket
SCSI
Connector