User manual

Chapter 2
8
!
Caution: If you operate the NASRaQ in an equipment rack, see
the precautions described in “Using Equipment Racks” on
page iv.
If you plan to use the NASRaQ on a ßat surface, attach the
rubber feet to the Þve indentations in the bottom of the case.
Figure 1 Attaching rubber feet
If you plan to operate the NASRaQ in an equipment rack,
Þrst connect the mounting ears to the sides of the NASRaQ
(as shown in Figure 2) near either the front or the rear of the
case. Ensure the supporting lip is placed under the unit to
provide additional support and attach the ears to the
equipment rack.
Figure 2 Installing NASRaQ into a standard rack
Rubber feet
Supporting Lip