User manual

Chapter 2: Setting up the RaQ XTR
18 Cobalt RaQ XTR User Manual
To configure the network manually:
1. When you see the prompt:
PRIMARY IP ADDR:
0
00.000.000.000
use the arrow buttons on the LCD console to enter the IP address assigned to
the RaQ XTR.
2. Press to accept the IP address.
If the IP address is valid, the next prompt appears:
ENTER NETMASK:
2
55.000.000.000
3. Enter the netmask of your network.
4. Press to accept the entry.
If the netmask is valid, the following prompt appears:
ENTER GATEWAY:
0
00.000.000.000
5. Enter the IP address of the gateway for your network.
If your network does not have a gateway, do not enter a number — leave the
default value, “000.000.000.000.”
6. Press to accept the entry
The LCD displays:
[S]AVE [C]ANCEL
7. To save the configuration information, use the left and right arrow buttons to
select [S]ave, and then press . After a few moments, you will see:
Verifying and Saving...
✍
Note: Selecting [C]ancel cancels the configuration and the
LCD screen displays
PRIMARY IP ADDR: again. You must go
through the entry process again.
E
E
E
E