User manual

Legato NetWorker

Cobalt RaQ XTR User Manual 273

Performing disaster recovery on a RaQ XTR with

Legato NetWorker

Preparing for disaster recovery

Prepare your RaQ XTR for disaster recovery by performing the following steps:

1. Perform an OS restore to wipe the hard disk drive and return the RaQ XTR

to a factory-fresh state.

2. Conﬁgure the RaQ XTR through the Setup Wizard and return it to the

network. The RaQ XTR must be able to communicate with the backup

server.

3. If possible, conﬁgure the RaQ XTR to use a network time protocol (NTP)

server to set the clock on the server.

On the Server Desktop, select Control Panel > Time to conﬁgure the time

settings or to specify an NTP server.

4. Select Backup and Restore > Legato NetWorker and conﬁgure the Legato

NetWorker client on the RaQ XTR.

• Enable Client—Click to enable the check box (check mark) to enable

the backup client.

• Legato Server Hostnames—Enter the fully qualified domain names of

Legato NetWorker backup servers. Legato servers must have valid host

names.

• Service port range—Sets the range of the system’s service ports to the

one specified (7937—9936).

• Connection Port Range—Sets the range of the system’s connection

ports to the one specified (10001—30000).

5. Click Save.

6. Select Backup and Restore > Control. The “Backup System Control” table

appears.

• Unlock the UI by disabling the check box Locked (no check mark).

• Turn on the services by enabling the check box Active (check mark).

7. Click Save Changes.