User manual

Appendix D: Advanced Information
236 Cobalt RaQ XTR User Manual
Serial console port
You can connect a console terminal to the DB-9 connector on the back panel of
the RaQ XTR. The terminal can be either an ASCII terminal or a PC running
terminal software. The console terminal should have the following
communications parameters—115 200 baud, 8 data bits, no parity and one stop
bit.
Initializing the RaQ XTR through the
serial console port
Instead of assigning the initial network settings for the RaQ XTR server through
the LCD console, you can connect the server to a terminal and assign the network
settings through the serial console port.
This feature allows the assignment of network parameters only (IP address,
netmask, gateway).
✍
Note: You can use the initialize the RaQ XTR through the serial
console port only once, much like proceeding through the
browser-based Setup Wizard.