User manual

Appendix C: Upgrading the RaQ XTR
220 Cobalt RaQ XTR User Manual
10. Re-insert the drive sled into the disk drive bay. Ensure that the track, on the
bottom of the drive sled, is correctly aligned with the track in the drive bay
(see Figure 104).
Figure 104. Re-inserting a drive sled
11. Push the drive sled into the bay until you feel it “snap” into place.
12. Rotate the front panel back to its original position.
13. Slide the front panel back into the chassis. Ensure that the cable, at the right
side of the front panel, enters the chassis without being pinched or kinked.
Drive Bay Track