User manual

Installing or removing a hard disk drive
Cobalt RaQ XTR User Manual 219
Figure 102. Withdrawing a drive sled
5. Remove the four mounting screws from the bottom of the drive sled (see
Figure 103).
Figure 103. Drive sled and disk drive
6. Lift the disk drive slightly away from the drive sled and gently unfasten the
power and data connectors from the rear of the drive.
7. Attach the data and power connectors, at the rear of the drive sled, to the
corresponding connectors on the new disk drive.
8. Position the drive on the sled so that the four holes in the sled’s bottom line
up with the threaded holes in the bottom of the disk drive.
9. Re-insert the mounting screws and fasten the drive to the sled.
Drive Sled
Mounting
Screws (4)
Disk Drive
Front Plate
Power
Connector
Data
Connector