User manual

Configure UPS

Cobalt RaQ XTR User Manual 199

To conﬁgure the RaQ XTR for the UPS, ﬁrst connect the UPS unit and the

RaQ XTR, and then conﬁgure the RaQ XTR through the LCD panel. (Refer to

the UPS manual for more information on connecting the devices.)

1. Plug the UPS into the wall socket.

2. Turn on the UPS.

3. Plug the RaQ XTR units into the UPS power sockets.

4. Connect the UPS serial cable to the UPS unit and the serial port on the

RaQ XTR that will serve as the master. See Figure 98.

5. On the LCD console, hold down the button for approximately

2 seconds.

The LCD screen displays:

SELECT:

SETUP NETWORK

6. Press the button until

CONFIGURE UPS

appears in the LCD

screen:

SELECT:

CONFIGURE UPS

7. Press the button.

8. Use the arrow buttons to toggle the cursor between [ ] On and [ ] Off.

Select [ ] On.

9. Press the button.

10. Use the arrow buttons to toggle the cursor between [M]aster and [S]lave.

11. Press the button. If you choose [M]aster, the RaQ XTR conﬁgures

itself automatically for the UPS.

☞

Important:

You must use the serial cable shipped with the UPS

unit.