User manual

Control panel
Cobalt RaQ XTR User Manual 143
Simple Network Management Protocol (SNMP) agent
If the SNMP agent is enabled, you can use SNMP software to remotely monitor
server information such as CPU utilization and network traffic.
You can enable or disable the Simple Network Management Protocol (SNMP)
agent:
1. Select Server Management > Control Panel. The “Service Settings” table
appears.
2. Click to enable (check mark) or disable (no check mark) the check box next
to Simple Network Management Protocol (SNMP) agent.
3. If you are disabling the SNMP agent, click Save Changes.
If you are enabling the SNMP agent, click on the green pencil icon for this
service in the “Service Settings” table. The “SNMP Parameters” table
appears; see Figure 63.
4. Enter the SNMP communities that can have read-only and read-and-write
access to this SNMP agent. The default read-access community is public.
5. Click Save Changes in the “SNMP Parameters” table.
6. Click Save Changes in the “Service Settings” table.
Figure 63 shows the “SNMP Parameters” table.
Figure 63. SNMP Parameters table