User manual

Appendix A

Using the LCD Console

During startup, the CacheRaQ’s LCD screen displays

status information relating to the boot process itself.

During setup, the LCD console is used to enter network

conﬁguration information.

Once the CacheRaQ is running, the LCD console also

serves multiple purposes:

• Change network conﬁguration information — useful

if the CacheRaQ’s location is changed.

• Reboot the system.

• Power down — necessary if you need to unplug the

CacheRaQ’s power.

• Reset network — resets all IP addresses, netmasks,

and other network information. This is useful if

incorrect data has been entered and you want to start

again.

IMPORTANT: Follow the proper power-down procedure before

turning off the CacheRaQ (see “Powering Down” on page 29).

You access each of these functions by holding down the

button (Select) for approximately two seconds. This

causes the LCD screen to enter its function mode. Then,

press the button until the function you want appears

on the LCD screen. To cancel the LCD’s function mode,

select the EXIT function, press the button (Enter),

then select [Y]ES.

Changing the Network Conﬁguration

To change Network 1 IP address or netmask, or to change

the CacheRaQ’s gateway, follow these steps:

1. From the LCD console, hold down the button

down for approximately 2 seconds.