User manual

Chapter 2

The LCD displays:

[S]AVE [C]ANCEL

8. To save the conﬁguration information, use the Left and Right

buttons to select [S]ave, and then press .

(If you enter Cancel instead, you return to step 6 above.)

If you enter Save, you’ll see:

VERIFYING AND SAVING

12After verifying and saving, the CacheRaQ then completes the

boot process, and the LCD screen shows several messages before

displaying the IP address assigned to Network 1.

Conﬁguration is complete when the LCD screen displays the

CacheRaQ’s Network 1 IP address, for example:

IP Address:

10.9.25.77

Any time you need to change the settings described above, see

“Changing the Network Conﬁguration” in Appendix A. It

explains how to return to this interface once the system is up and

running. Appendix A also describes other options available from

the LCD panel interface.

Phase 2: Setting Up With the Browser

After you've conﬁgured the CacheRaQ's Network 1 interface and

gateway, you can complete the conﬁguration procedure using a

Web browser. You will need to use a browser that supports

HTML frames and JavaScript. Netscape Navigator or Microsoft

Internet Explorer, versions 3.0 or later, will work. Once the setup

process is complete, the CacheRaQ can be managed from any

browser-enabled computer on the network.

To begin browser-based conﬁguration:

1. Launch the Web browser on any computer connected to the

network.

2. Be sure to enable JavaScript in your browser, if you normally

disable it.