User manual

Setting Up the Cobalt CacheRaQ
9
If you plan to operate the CacheRaQ in an equipment rack, first
connect the mounting ears to the sides of the CacheRaQ (as
shown in the next figure), near either the front or the rear of the
case. Then attach the ears to the equipment rack.
Connecting to the Network
Once you’ve determined which of the CacheRaQ's network
interface(s) to use, connect the interface(s) to your network with
twisted-pair Ethernet cabling (see the following diagram).
Connecting the Power Supply
Connect the power supply cord to an electrical outlet (100-240
volts AC, 50/60 Hz, as listed in Appendix B).
Powering On the CacheRaQ
Turn on the power by pressing the On/Off switch on the back
panel.
The hard disk spins up and the fan turns on. The Cobalt logo
indicator light on the front blinks a few times and then glows
steadily.
Status messages appear on the LCD screen as the CacheRaQ
completes its boot process.
Serial
100 - 240 VAC 50/60 Hz
1.0 A 40W max
Tx/Rx
Link
100 M
Col
OK to
Power Off
Cobalt Networks and Cobalt CacheRaQ
are trademarks of Cobalt Networks, Inc.
S/N PPPPPMYWWSSSS
R15 664 NCU
CacheRaQ
Network 1
www.cobaltnet.com
Tx/Rx
Link
100 M
Col
Network 2
Network 2
Network 1
Power