User manual

Control panel
Cobalt RaQ 4 User Manual 67
Applying a bandwidth limit
To apply a bandwidth limit to an IP address:
1. On the Server Management screen, click Control Panel on the left. The
Service Settings table appears.
2. Click Bandwidth at the top. The Bandwidth Limits table appears.
3. Click Add. The Add Bandwidth Limit table appears. See Figure 27.
4. In the first row of the table, select from the pull-down menu the IP address to
which you want to apply the bandwidth limit. The pull-down menu lists all
the IP addresses that do not currently have a bandwidth limit.
5. In the second row, enter the value of the bandwidth limit in Kb/s. The
minimum value is 10 Kb/s.
6. Click Save Changes. The screen refreshes and the Bandwidth Limits table is
displayed with the IP address and the bandwidth limit.
✍
Note: If each of the IP addresses on the RaQ 4 already has a
bandwidth limit assigned to it, an error message at the bottom of the
screen alerts you to this fact.
To modify a bandwidth limit, see “Modifying a bandwidth limit” on
page 68. To delete a bandwidth limit, see “Deleting a bandwidth
limit” on page 69.