User manual

Chapter 3: RaQ 4 Server Management
60 Cobalt RaQ 4 User Manual
Legato file backup
You can use the Legato NetWorker® client software to support backup and
restore needs on the RaQ 4. To use this feature, you must install the Legato
Networker Server software. The software is available at www.legato.com.
To enable or disable the Legato file backup option:
1. On the Server Management screen, click Control Panel. The Service
Settings table appears.
2. Click the check box next to Legato File Backup to on or off.
3. If you are disabling the Legato File Backup option, click Save Changes.
If you are enabling the Legato File Backup option, click on the Parameters
link next to the option in the Service Settings table. The Legato Networker
Parameters table appears.
4. In the Legato Networker Parameters table, enter the host name and the
IP address of the Legato Server in the fields.
5. Click Save Changes in the Legato Networker Parameters table.
6. Click Save Changes in the Service Settings table.
Figure 22 shows the Legato Networker Parameters table.
Figure 22. Legato Networker Parameters table