User manual

Control panel
Cobalt RaQ 4 User Manual 59
Simple Network Management Protocol (SNMP) agent
If the SNMP agent is enabled, you can use SNMP software to remotely monitor
server information such as CPU utilization and network traffic.
You can enable or disable the Simple Network Management Protocol (SNMP)
agent:
1. On the Server Management screen, click Control Panel. The Service
Settings table appears.
2. Click the check box next to Simple Network Management Protocol (SNMP)
agent to on or off.
3. If you are disabling the SNMP agent, click Save Changes.
If you are enabling the SNMP agent, click on the Parameters link next to
the option in the Service Settings table. The SNMP Parameters table appears.
4. Enter the SNMP communities that can have read-only and read-and-write
access to this SNMP agent. The default read-access community is “public”.
5. Click Save Changes in the SNMP Parameters table.
6. Click Save Changes in the Service Settings table.
Figure 21 shows the SNMP Parameters table.
Figure 21. SNMP Parameters table