User manual

Control panel
Cobalt RaQ 4 User Manual 53
To manage the settings for the RaQ 4 services:
1. On the Server Management screen, click Control Panel on the left. The
Service Settings table appears.
2. To turn on any of the services listed in the Service Settings table (except Web
server, which is always on), click the check box next to that service. The
services are described in the sections that follow.
3. Click Save Changes.
Web server
This service is always on. It allows site users to access Web content, as described
in Chapter 5.
Email server
The RaQ 4 supports email for each virtual site on the host. It also supports email
for entire domains (for example, www.mydomain.com). By default, each
registered user has an email account created on the RaQ 4.
The RaQ 4 supports multiple client and server email protocols but does not
implement virtual email users. This means that for the entire RaQ 4, each user
must have a unique username, even if the users are on different virtual sites. For
more information, see “Email relaying” on page 56.
SMTP server
The RaQ 4 can act as a Simple Mail Transfer Protocol (SMTP) server for sending
and receiving Internet email. As the RaQ 4 Administrator, you can configure
several parameters that can affect the performance of the SMTP server.
Users created on any virtual site can retrieve their email using the Post Office
Protocol 3 (POP3) or the Authentication Post Office Protocol (APOP), in
addition to the Internet Message Access Protocol 4 (IMAP4). Users can send
mail using the Simple Mail Transfer Protocol (SMTP).
✍
Note: Chapter 5 provides instructions for site users on how to use
the RaQ 4 services.