User manual

Phase 2: Setting up with the Web browser
Cobalt RaQ 4 User Manual 29
After setup has been completed, the Services page in the Control Panel has a
“Parameters” column which enables further configuration. Refer to “Control
panel” on page 52 for additional information.
Entering the time settings
In the Time Settings table, select the time and date with the pull-down menus.
See Figure 12.
Select the correct time zone by clicking in the Region, Country and Locale/Zone
fields.
Completing configuration with the Setup Wizard
When you have entered the information in the Setup Wizard, click Save
Changes.
The RaQ 4 performs automatic checks on the information entered and alerts you
if an illegal value or a problem is encountered. If the information is correct, the
RaQ 4 enters the information in its configuration files.
Registering the RaQ 4 online
The RaQ 4 displays an online product registration page; see Figure 13.
☞
Important: If you leave blank either the DNS or the Gateway fields
in the Setup Wizard, you cannot register the RaQ 4 online because
you will not be able to send email. In this case, if you attempt to
register the RaQ 4 online, you receive an error message, stating that
you cannot register online because you did not fill in the DNS and
Gateway fields.
✍
Note: If you are not connected to the Internet, you cannot register
online.