User manual

Phase 2: Setting up with the Web browser
Cobalt RaQ 4 User Manual 27
For informational purposes, this table also displays the IP address of the RaQ 4,
the subnet mask of your network, your configured gateway and the Media Access
Control (MAC) address that uniquely identifies this RaQ 4. These settings, with
the exception of the MAC address, can be changed later from the Control Panel
section of the Server Management screen.
Entering the administrator settings
In the Administrator Settings table, enter the information about the RaQ 4
Administrator. The RaQ 4 Administrator has several responsibilities:
1. Setting up and maintaining the RaQ 4, virtual sites, virtual Site
Administrators, site users and services
2. Responding to RaQ 4 email alerts to prevent potential problems
To set up the RaQ 4 Administrator, you must enter a password in the
Administrator Password field and then enter the same value again in the second
Administrator Password field.
Password guidelines
The RaQ 4 supports long passwords through the user interface (UI). Passwords
were previously limited to 8 characters.
Use the following guidelines when choosing a password:
1. The valid characters include: a-z A-Z 0-9 % ! @ $ ^ & * - _ = + \ |
. , / ? ; :
2. Use both upper- and lower-case letters.
3. Do not use a proper name.
4. Do not use a word found in a dictionary.
5. Do not use a date.
6. Do not use a command word.
7. Do not use a string of consecutive keys on a keyboard (for example,
“qwerty”).
Be sure to remember this password to access the RaQ 4’s management
administration features in the future. If you forget or want to reset the password,
see “Resetting the RaQ 4 Administrator password” on page 51.
✍
Note: A password is case-sensitive.