User manual

Phase 1: Making the connection
Cobalt RaQ 4 User Manual 23
The arrow buttons function as follows:
The Left arrow button moves the cursor to the left.
The Right arrow button moves the cursor to the right.
The Up arrow button increases the digit located at the cursor position.
The Down arrow button decreases the digit located at the cursor position.
The S button (“select”) displays the next option.
The E button (“enter”) accepts the information entered or the option
displayed.
Setting the configuration
During setup, the LCD console is used to enter network configuration
information on the RaQ 4.
Follow these steps to configure the network manually:
1. When you see the prompt
ENTER IP ADDR:
0
00.000.000.000
enter the IP address assigned to the RaQ 4 using the arrow buttons on the
LCD console.
2. Press .
If the IP address is valid, the next prompt appears:
ENTER NETMASK:
2
55.000.000.000
3. Enter the netmask of your network.
4. Press .
If the netmask is valid, the following prompt appears:
ENTER GATEWAY:
0
00.000.000.000
S
E
E
E