User manual

Phase 1: Making the connection
Cobalt RaQ 4 User Manual 21
Connecting to the network
Connect one end of a Category 5 Ethernet cable to the 10/100 Base-T Network 1
connector on the RaQ 4; see Figure 8. Connect the other end of the cable to an
existing network socket.
Figure 8. Network connectors
Connecting the power cord
Connect the power supply cord to the RaQ 4 and to an electrical outlet
(100-240 volts AC, 50/60 Hz, as listed in “Physical data” on page 159).
Powering on the RaQ 4
Turn on the power by pressing the On/Off switch on the back of the RaQ 4.
The hard disk drive spins up, the fan turns on, and the LCD screen lights up. The
Cobalt logo and the Cobalt Networks name scroll across the screen.
A number of status messages are displayed on the LCD screen as the RaQ 4
completes its boot process.
✍
Caution: It is important to follow the proper power-down
procedure before turning off the RaQ 4. Refer to “Powering down”
on page 155.
100 - 240 VAC 50/60 Hz
1.4 A 60W max
Cobalt Networks and Cobalt RaQ are 
trademarks of Cobalt Networks, Inc.
www.cobalt.com
P/N 550-00135-01
Link Tx/Rx Link Tx/Rx
Network connection 1
Network connection 2
Raq 4i / RaQ 4r configurations
Raq 4 configuration
100 - 240 VAC 50/60 Hz
1.4 A 60W max
Cobalt Networks and Cobalt RaQ are 
trademarks of Cobalt Networks, Inc.
www.cobalt.com
P/N 550-00135-01
Link Tx/Rx
Network connection 1