User manual

Chapter 2: Setting up the RaQ 4
20 Cobalt RaQ 4 User Manual
If you plan to use the RaQ 4 on a flat surface, attach the rubber feet to the five
indentations in the bottom of the case; see Figure 6.
Figure 6. Rubber feet for the RaQ 4
If you plan to operate the RaQ 4 in an equipment rack, first connect the mounting
ears to the sides of the RaQ 4 (see Figure 7), near either the front or the rear of
the case. Attach the ears to the equipment rack.
Figure 7. Mounting ears for the RaQ 4
Rubber feet
S
E
S
E
S
E