User manual

Cobalt RaQ 4 User Manual 19

Chapter 2

Setting up the RaQ 4

This chapter guides you through the process of connecting and conﬁguring the

RaQ 4 for your network. A typical setup process takes less than 15 minutes, after

which you can begin setting up Web sites and using other RaQ 4 services.

If the RaQ 4 has been previously conﬁgured for a different network, refer to

“Changing network conﬁguration” on page 150.

The setup process consists of two phases.

• “Phase 1: Making the connection” covers the physical setup and connection

of the RaQ 4 to a power source and the network.

• “Phase 2: Setting up with the Web browser” covers the network integration

process and allows the administrator to select services and create users and

groups, using any browser-enabled computer.

Phase 1: Making the connection

Installing the RaQ 4

The RaQ 4 can either be placed on a ﬂat surface—for example, a desk, shelf or

table top—or it can be connected to a standard 19-inch equipment rack.

✍

Caution: If you operate the RaQ 4 in an equipment rack, see the

precautions described in “5. Operating the unit in an equipment

rack” on page iv.