User manual

Appendix A: Using the LCD Console

152 Cobalt RaQ 4 User Manual

To conﬁgure the RaQ 4 for the UPS, ﬁrst connect the UPS unit and the RaQ 4,

and then conﬁgure the RaQ 4 through the LCD panel. (Refer to the UPS manual

for more information on connecting the devices.)

1. Plug the UPS into the wall socket.

2. Turn on the UPS.

3. Plug the RaQ 4 servers into the UPS power sockets.

4. Connect the UPS serial cable to the UPS unit and the serial port on the

RaQ 4 that will serve as the master. See Figure 58.

5. On the LCD console, hold down the button for approximately

2 seconds.

The LCD screen displays:

SELECT:

SETUP NETWORK

6. Press the button until

Conﬁgure UPS

appears in the LCD screen:

SELECT:

CONFIGURE UPS

7. Press the button.

8. Use the arrow buttons to toggle the cursor between [ ] On and [ ] Off.

Select [ ] On.

9. Press the button.

10. Use the arrow buttons to toggle the cursor between [M]aster and [S]lave.

11. Press the button. If you choose [M]aster, the RaQ 4 conﬁgures itself

automatically for the UPS.

☞

Important:

You must use the serial cable shipped with the UPS

unit.