User manual

Appendix A: Using the LCD Console
150 Cobalt RaQ 4 User Manual
Changing network configuration
To reset the IP address or change the network configuration of the Network 1
interface:
1. On the LCD console, hold down the button for approximately
2 seconds.
The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button.
3. Enter the IP address using the arrow buttons. The left and right arrow buttons
move the cursor position to the left or right. The up and down arrow buttons
increase or decrease the digit at the cursor position.
4. Press the button.
5. Enter the Netmask using the arrow buttons.
6. Press the button.
7. Enter the Gateway using the arrow buttons.
8. Press the button.
9. Use the arrow buttons to toggle the cursor between [S]ave and [C]ancel.
10. Press the button.
If you select the Save option, the RaQ 4 reboots using the new network
configuration. If you select Cancel, you return to step 1 of this procedure.
✍
Note: You can also change the network configuration of the RaQ 4
through the Web browser. See “Network” on page 64.
If you change the network IP address of the RaQ 4 through the Web
browser, the RaQ 4 reboots automatically when you click Save
Changes .
S
E
E
E
E
E