User manual

Appendix A: Using the LCD Console
56 Cobalt CacheRaQ 4 User Manual
Set up network
To reset the IP address or change the network configuration of the Network 1
interface:
1. On the LCD console, hold down the button for approximately two
seconds. The LCD screen displays:
SELECT:
SETUP NETWORK
2. Press the button.
3. Enter the IP address using the arrow buttons. The left and right arrow buttons
move the cursor position to the left or right. The up and down arrow buttons
increase or decrease the digit at the cursor position.
4. Press the button.
5. Enter the netmask using the arrow buttons.
6. Press the button.
7. Enter the Gateway using the arrow buttons.
8. Press the button.
9. Use the arrow buttons to toggle the cursor between [S]ave and [C]ancel.
If you select Save, the CacheRaQ 4 reboots using the new network
configuration. If you select Cancel, you return to step 1 of this procedure.
10. Press the button.
S
E
E
E
E
E