User manual

Phase 1: Making the connection
Cobalt CacheRaQ 4 User Manual 13
If you plan to operate the CacheRaQ 4 in an equipment rack, first connect the
mounting ears to the sides of the CacheRaQ 4 (see Figure 5), near either the front
or the rear of the case. Attach the ears to the equipment rack.
Figure 5. Mounting ears for the CacheRaQ 4
Connecting to the network
Determine which of the CacheRaQ 4’s network interface(s) to use, according to
the mode of operation you have chosen; see “Mode of operation” on page 11.
Connect one end of a Category 5 Ethernet cable to the 10/100 BaseT Network 1
connector on the CacheRaQ 4; see Figure 6. Connect the other end of the cable to
an existing network socket.
Figure 6. Network connectors
S
E
S
E
100 - 240 VAC 50/60 Hz
1.4 A 60W max
Cobalt Networks and Cobalt CacheRaQ
are trademarks of Cobalt Networks, Inc.
www.cobalt.com
P/N 550-00192-01
Link Tx/Rx Link Tx/Rx
Network connection 1
Network connection 2