Product manual

2 Setting Up 9084 Network Remote Control
2-6 9084 PRODUCT MANUAL 9084-OM (V4.5)
Setting Up 9084 Network Remote Control
Perform remote control setup in accordance with Cobalt
®
reference guide
“COMPASS
®
Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt
®
reference guide COMPASS™
Remote Control User Guide (PN 9000RCS-RM) provides thorough infor-
mation and step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
®
OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Reference
Documents link at www.cobaltdigital.com and then select DashBoard
Remote Control Setup Guide as a download, or contact Cobalt
®
as listed in
Contact Cobalt Digital Inc. (p. 1-15).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
RM20-9084-B/S Split Rear Module. Provides each of the following
connections for two 9084 cards:
• HD/SD-SDI coaxial input (SDI IN)
• Four HD/SD-SDI reclocked input copies
(RCK OUT 1 thru RCK OUT 1)
• Four buffered SDI coaxial outputs (SDI OUT 1 thru
SDI OUT 4)
Note: Available equipped with High-Density BNC
(HDBNC) or DIN1.0/2.3 connectors as:
RM20-9084-B/S-HDBNC or RM20-9084-B/S-DIN,
respectively.
Table 2-1 9084 Rear I/O Modules — continued
9084 Rear I/O Module Description