Product manual

9084-OM (V4.5) 9084 PRODUCT MANUAL 2-3
Installation and Setup Installing a Rear I/O Module
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9084 Network Remote Control (p. 2-6).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Installing a Rear I/O Module
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9084 is to be installed.
If installing the 9084 in a slot already equipped with a suitable I/O module,
omit this procedure and go to Installing the 9084 Into a Frame Slot (p. 2-1).
Install a Rear I/O Module as follows:
1. On the frame, determine the slot in which the 9084 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-1.