Owner`s manual

Page 16 of 23 9033 Owner’s Manual •
••
• (V 0.5)
AnX Analog Audio channel X (1 through 8)
AeXX Discrete AES channel XX (1 through 16)
Output Gain
The gain of each output is adjustable from +30 dB to –100 dB in 0.1 dB steps. After –100 dB gain is
set to –Inf, which means that output is present, but muted.
Output Polarity
If set to “Norm” output polarity is the same as input polarity, if set to “Inv” the output polarity is
inverted. This can be used to correct polarity errors in the input signals fed to the card.
Display Orientation
This parameter lets you change the orientation of the display. “Vert” makes the characters look correct
when the cards are mounted in a 2 RU frame like the 8310. “Horz” makes the characters look right in a
horizontal frame.
Display Brightness
This parameter allows you to set the standard output brightness of the menu display. It is a percentage
of maximum brightness.
Save Settings
In this parameter, move the toggle switch up to save the settings to the card persistent storage.
Load Settings
In this parameter, move the toggle switch up to load the saved settings and make them active.
Restore Factory Settings
In this parameter, move the toggle switch up to make the factory default settings active, and make the
stored settings equal to the factory settings.
Info
This menu gives information about the card including, positive and negative power consumption in
watts, software release number, and software build number.
Factory Default Settings
The factory default settings are as follows:
1) The proc module is enabled, but all parameters are set to not change the video.
2) The video decoder is set to Component SMPTE for SD and YpbPr for HD.
3) Discrete AES inputs 1-16 are mapped to embedded audio outputs 1-16.
4) Audio gain is set to 0dB and polarity is set to normal on all channels.