Specifications

Project #2008377 VIDEO PRODUCTION SYSTEM
Section 11130 (or 27 41 30)
Page 30
Video Production Redesign FBC Highland Park
Landover, Indiana
10/07/2013
Report transport layer errors
RGB-HV.
0.707 to 1.0 volt maximum throughout RGB video signal path.
to 1.414 volt maximum throughout HV sync signal path
Control functions shall be checked for proper operation, from controlling devices to controlled devices.
Adjust, balance, and align equipment for optimum quality and to meet the manufacturer's published
specifications. Establish and mark normal settings for each level control, and record these settings,
in the "System Operation and Maintenance Manual".
Installed and loose equipment shall be inventoried for correct Qty.
Any other test on any piece of equipment or system deemed appropriate by Consultant.
The omission of a description of a device, function, signal path, or test in this document shall not
exempt the Contractor from responsibility for checking all devices and signal paths for appropriate
compliance with Industry Performance Standards and making corrections necessary to bring
system(s) into compliance with the applicable standards.
3.6 TEST EQUIPMENT
Provide the following equipment on site for final acceptance testing. Test equipment to be available for the
entire period through final system acceptance. Prior to start of testing, provide a list to the Consultant of
test equipment make and model numbers that will be used.
Megohmeter.
Multimeter: Measurement range, DC to 20,000 Hz, 100 mV to 300 V, 10 ma to 10A. Acceptable:
Fluke 75.
Dual-trace oscilloscope: 20 MHz bandwidth, 1 mV/cm sensitivity.
Impedance Meter: Capable of testing audio lines at three frequencies, minimum, between 250 Hz
and 4k Hz. Measurement Range: 1 ohm to 100k ohms.
Audio Oscillator: bandwidth 20 Hz to 20k Hz +1 dB at 0 dBm output. Output to be balanced. Oscillator
to include adjustable output level.
Time Domain Reflectometer.
Optical Time Domain Reflectometer.
HD-SDI Generator
HD-SDI Analyzer/Waveform/Vectorscope
CAT5E/6 Cable Tester
HD/SD portable color monitor
3.7 INSTRUCTION OF OWNER PERSONNEL
Upon completion of the installation of the specified AV systems, and prior to any facility events, provide
designated operating personnel training on the equipment operation. This training will be performed at the
site by the Contractor’s and the manufacturer's education staff.
The System Reference and Service Manuals must be complete and on-site prior to the time of the first
instruction.
Coordinate schedule of instruction with the Owner subject to availability of Owner’s personnel. This may
require scheduling instruction during weekends or evenings.