Owner`s manual

13
DIP Switch Settings
Figure 5. Card-edge User Controls
Switch Mode
SW1-1 SW1-2
OFF OFF Stereo DA (Dual 1x4)
OFF ON Mono Mix (Sum CH1 and CH2)
ON OFF Mono DA (CH1 > 1x8)
SW1-1, SW1-2
(Audio mode)
ON ON Reserved
ON Get card parameters from non volatile memory, ignore
dip switch settings. (Configurable with DashBoard
Control system)
SW2
(Power-up defaults)
OFF Get card parameters from the DIP switch
ON
Card edge control enabled.
DashBoard control disabled.
Only card status is available on Dashboard. Users are
prevented from changing parameters using DashBoard.
SW3
(Card edge control
enable)
OFF
Card edge control disabled.
DashBoard control enabled.
Full, normal DashBoard access and control of all card
controls and parameters.
ON
OFF
SW1-1 SW1-2 SW 2 SW 3