User manual

SP-5000M-CXP2 / SP-5000C-CXP2
- 34 -
Table 38. Associated GenICam register information
GenICam Name
Access
Values
Category
Exposure Mode
R/W
Off
Timed
TriggerWidth
Acquisition Control
Trigger Mode
R/W
Off
On
Acquisition Control
Trigger Option
R/W
Off
RCT
PIV
RCT Continuous
JAI-Custom
7.2.2 Exposure Time
This command is effective only when Exposure Mode is set to Timed. It is for setting exposure time.
The setting step for exposure time is 1 μsec per step.
Minimum: 10 μsec
Maximum: 8 seconds
Associated GenICam register
GenICam
Name
Access
Values
Category
Exposure
Mode
R/W
Off
Timed
TriggerWidth
Acquisition Control
Exposure
Time
R/W
10 to
1000000 [us]
Acquisition Control
Exposure
Time
Raw
R/W
10 to
1000000 [us]
Acquisition Control
7.2.3 Exposure Auto
This is a function to control the exposure automatically. It is effective only for Timed.
JAI ALC Reference controls the brightness.
There are three modes, OFF, Once and Continuous.
OFF: No exposure control
Once: Exposure adjusts when the function is set, then remains at that setting
Continuous: Exposure continues to be adjusted automatically
In this mode, the following settings are available.
ALC Speed: Rate of adjustment can be set
ASC Max: The maximum value for the exposure time to be controlled can
be set
ASCMin: The minimum value for the exposure time to be controlled can
be set
ALC Reference: The reference level of the exposure control can be set
ALC Channel area: The measurement area of the exposure control can be set