User manual

SP-5000M-CXP2 / SP-5000C-CXP2
- 18 -
5.3.7.2 IN and OUT matrix table
The following table shows the input and output matrix table.
Table – 10 GPIO IN and OUT matrix table
Selector (Cross
point switch output)
Source signal
(Cross point switch input)
LOW
              
HIGH
              
Line 4 - 12P TTL In
              
Line 5 - 12P OPT In
              
Line 7 - Trigger packet
              
NAND 0 Out 1
              
NAND 1 Out 1
              
Pulse Generator 0
              
Pulse Generator 1
              
Pulse Generator 2
              
Pulse Generator 3
              
User Output 0
              
User Output 1
              
User Output 2
              
User Output 3
              
Software Trigger
              
FVAL
              
LVAL
              
Exposure Active
              
Acquisition Trigger Wait
              
Acquisition Active
              
Frame Trigger Wait
              
Frame Active
              
Line 10 - TTL 2 In
              
Line 11 - LVDS 1 In
              
Extension GPIO
Connection
NAND 2 In 2
Pulse Generator 0
Pulse Generator 1
Pulse Generator 2
Pulse Generator 3
Trigger Source
Pulse Generator
Clear Source
Line Source
Line 9 - TTL 3 Out
NAND 1 In 1
NAND 1 In 2
NAND 2 In 1
Trigger
Selector
Line Selector
Pulse Generator
Selector
Acquisition Start
Acquisition Stop
Frame Start
Line 1 - 12P TTL Out 1
Line 8 - TTL 2 Out
Line 2 - 12P Opt Out 1
Note: As for Line 8, Line 9, Line 10 and Line 11 are available if AUX Type 3 is used for AUX connector
configuration.