User manual

SP-5000M-CXP2 / SP-5000C-CXP2
- 17 -
5.3.6 Line Format
Controls the format of the line item selected in Line Selector.
(No Connect, TTL, LVDS, Opt Coupled)
5.3.7 GPIO
This is a general interface for input and output and controls input and output for trigger signals or
valid signals and pulse generator. By using this interface, you can control an external light source,
make a delayed function to input a trigger signal or make a precise exposure control with PWC
trigger.
5.3.7.1 Basic block diagram
Soft Trigger
LVAL IN
FVAL IN
Exposure Active
Acquisition Trigger Wait
Acquisition Active
Frame Trigger Wait
Frame Active
User output 0
User output 1
User output 2
User output 3
GPIO 4 (TTL IN 1)
GPIO 5 (OPT IN 1)
GPIO 7 (Trigger Packet)
GPIO 10 (TTL IN2)
GPIO 11 (LVDS IN)
Pixel Clock
Cross Pont
Switch
12 bit Counter
INV
INV
INV N
NAND
INV
Non INV
Pulse Generator
20 bit counter x 4
CLR
Trigger 0 (Acquisition Start)
Sel Bit (5,0) Sel Bit (7)
Sel Bit (7)
Pulse Generator 0
Pulse Generator 1
Pulse Generator 2
Pulse Generator 3
Trigger 1 (Acquisition Stop)
Trigger 2 (Frame Start)
GPIO 1 (TTL OUT 1)
GPIO 2 (OPT OUT 1)
GPIO 8 (TL OUT 2)
GPIO 9 (TTL OUT 3)
Sel Bit (7)
Note1: There are three pixel clocks available. Pixel clock is related to Link Configuration.
If Link Configuration is set, the appropriate pixel clock is automatically used.
Note2: Items written in blue are available only if Type 3 is selected for AUX connector.
Fig. 6 GPIO