ITEM:700771 ASSEMBLY INSTRUCTION ASSEMBLY TIPS: 1. Remove hardware from box and sort by size. 2. Please check to see that all hardware and parts are present prior to start of assembly. 3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly. A Warning ! 1. Don't attempt to repair or modify parts that are broken or defective . Please contact the store immediately. 2. This product is for home use only and not intended for commercial establishment.
ITEM:460331 ASSEMBLY INSTRUCTION PARTS IDENTIFICATION z HARDWARE PACKAGE FOR TV STAND NO DESCRIPTION FIGURE QTY 1 LARGE BOLT PCS 2 MEDIUM BOLT "x13" PCS 3 SMALL BOLT 1" PCS 4 |PHILLIPS HEAD BOLT i PCS 5 LARGE WASHER PCS 6 SMALL WASHER PCS 7 | ALLEN WRENCH — J.
ITEM:460331 ASSEMBLY INSTRUCTION ASSEMBLY Do not fully tighten all bolts until assembly is complete. This will help all parts to assemble properly. Assembly time 30 minutes. Two people needed. STEP 1: Attach left front post (A) Left back post (B) and cross bar (F) to left guard rail (G) using bolt (3) and tighten with Allen wrench (7) Attach right front post (C) right back post (D) and cross bar (F) to right guard rail (H) using bolt (3) and tighten with Allen wrench (7).
ASSEMBLY INSTRUCTION ITEM:460331 PCS PCS Goa STEP 3:Attach mattress frame (E) to assembled frame using bolt (3), small washer (6) and tighten with Allen wrench (7). XX ROO GRO oe NOB A COCOON BOTS ROOF bolt {1), washer (5) and tighten with Allen STEP 4:Attach ladder (K) to front guard rail (J) using wrench (7). BLEEPER Wo \ SLO OF ARON RANGERS fh 0) AJAX QUA REN AAR EN XEN AR 000 Www .
ITEM:460331 ASSEMBLY INSTRUCTION STEP 5: Attach canopy tube 1 (L) to canopy tube 2 (M}) using bolt (4). 4 Cum PCS STEP 6: Attach canopy cross bar (N) to assembled canopy frame using { 2 PCS bolt(2) and tighten with Allen wrench (7).
ASSEMBLY INSTRUCTION ITEM:460331 Om PCS 4 STEP 7: Attach assembled canopy frame to to back guard rail (1), front guard rail (J) using bolt (4). STEP 8: Attach top tent (O) to guard rails. A www.coastercompany.
ASSEMBLY INSTRUCTION ITEM:460331 STEP 9: Attach bottom tent (P) by tying it to the bottom frame = ATT SOAR AVE OLA A Nir /4 \ NWN) STEP 10: Complete www.coastercompany.com COASTER.
ITEM:460331 ASSEMBLY INSTRUCTION Safety Warnings 1.Follow the information on the warnings appearing on the upper bunk end structure and on the carton . Do not remove warning label from bed. 2.Always use the recommended size mattress or mattress support to prevent the likelihood of being trapped or falling over. The proper mattress size for the UPPER bunk MUST BE 74"to 75" long 1"wide x 6" high (no higher than 6"). 3.Surface of mattress must be at least 5 in(127mm). below the upper edge of guardrails . 4.
