ITEM:460229 ASSEMBLY INSTRUCTION ASSEMBLY INSTRUCTIONS ASSEMBLY TIPS: 1. Remove hardware from box and sort by size. 2. Please check to see that all hardware and parts are present prior to start of assembly. 3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly. A Warning ! 1. Don't attempt to repair or modify parts that are broken or defective . Please contact the store immediately. 2.
ITEM: 460229 ASSEMBLY INSTRUCTION ASSEMBLY DO NOT fully tighten all bolts until assembly is complete. This will help all parts to 1 4PCS| assemble properly. 6 0 4pCS| Step 1:Align and attach right guardrail (G) to right front {C) and back post (D) using bolt (1), washer (6) and tighten with Allen wrench (7). As shown in drawing.
ITEM: 460229 ASSEMBLY INSTRUCTION Step 3:Align and attach left guardrail {F) and left connector (M) te right posts (C) & {D} using bolt (1), washer (6) and tighten with Allen wrench (7). As shown in drawing. 1 @mm PCS 6 © orcs 7 — LEFT SIDE Step 4:Align and attach the bottom panel {I} to left end post (B) using bolt (4) and 4 tighten with Allen wrench (7). As shown in drawing. @ PCS 7 www .
ASSEMBLY INSTRUCTION Step 5:Align and attach the front and back guardrails (E) to the end post (B} & {D} and front post (A) & (C) using bolt (2), washer (6) and tighten with Allen wrench (7}. As ITEM:460229 shown in drawing Gum PCS [NC] 2 Step 6:Align and attach the mattress frame (L) to front and back guard rails {E} using bolt (1), washer (6) and tighten with Allen wrench (7). As shown in drawing 12PCS| 1 www .
ASSEMBLY INSTRUCTION ITEM: 460229 Step 7:Align and attach the back support tube {J} to end post (B) & {D) using bolt (2), washer (6) and tighten with Allen wrench (7). As shown in drawing. Step 8:Align and attach the desk support tube (K) to the back support tube (J) and mattress frame {L) using bolt (1), bolt (5), washer (6) and tighten with Allen wrench {7). As shown in drawing. www .
ASSEMBLY INSTRUCTION ITEM: 460229 Step 9:Align and attach desk top (O) to the support tube (K} and back support tube (J) using bolt (4), washer (8) and tighten with Allen wrench (7). As shown in drawing. STEP 10:COMPLETE. www .
ITEM: 460229 ASSEMBLY INSTRUCTION Safety Warnings 1.Follow the information on the warnings appearing on the upper bunk end structure and on the carton . Do not remove waning label from bed. 2.Always use the recommended size mattress or mattress support,or both,to help prevent the likelihood of entrapment or falls. 3.Surface of mattress must be at least the upper edge of guardrails . 4.Do not allow children under 6 years of age to use the upper bunk. 5.
