ITEM:460078 ASSEMBLY INSTRUCTION ASSEMBLY TIPS: 1. Remove hardware from box and sort by size. 2. Please check to see that all hardware and parts are present prior to start of assembly. 3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly. A Warning ! 1. Don't attempt to repair or modify parts that are broken or defective . Please contact the store immediately. 2. This product is for home use only and not intended for commercial establishment.
ITEM:460078 ASSEMBLY INSTRUCTION ASSEMBLY Do not fully tighten all bolts until assembly is complete. This will help all parts to assemble properly. STEP 1:Align and attach the bottom adjustable leveler to the front and back frame. STEP 2:Align and attach the upper base frame to the front and back frame by using bolt, washer and tighten with the Allen follow the drawing for the which size bolt to use). 0 ASTER. www.
ITEM:460078 ASSEMBLY INSTRUCTION STEP 3:Align and attach the side guardrail to the upper bed by using the bolt, washer and tighten with the Allen wrench. STEP 4:Align and attach the front and back guardrail to the upper — bed by using bolt, washer and tighten with the Allen wrench. | 2 2 PCS (Note: follow the drawing for the which size bolt to use). PCs © 14pPcs 0 ASTER. www.
ITEM:460078 ASSEMBLY INSTRUCTION STEP 5: Align and attach the top and bottom cross tube to the front and back frame by using the bolt (1), washer and tighten with the Allen wrench. NOTE:PLEASE TIGHTEN THESE 6 BOLTS IN THIS STEP. STEP 6:Align and attach the lower base frame to the front and 4 Gm PCS back frame by using bolt, washer and tighten with the 6 (9) PCS Allen wrench. (Note: follow the drawing for the which size 71 bolt to use). C O ASTER www .
ASSEMBLY INSTRUCTION ITEM:460078 PCS STEP 7:Align and attach the support legs to the lower base frame by | 4 PCS 5 using the bolt (3), washer and tighten with the Allen wrench. PCS © PCS 5 upper base frame by using the bolt (5), washer and tighten STEP 8:Align and attach the support to the front and back frame and | 3 PCS with the Allen wrench. 4 4 ELLA X www.
ITEM:460078 ASSEMBLY INSTRUCTION Safety Warnings 1.Follow the information on the warnings appearing on the upper bunk end structure and on the carton . Do not remove waning label from bed. 2 Always use the recommended size mattress or mattress support,or both,to help prevent the likelihood of entrapment or falls. 3.Surface of mattress must be at least 5 in(127mm). below the upper edge of guardrails . 4.Do not allow children under 6 years of age to use the upper bunk. 5.
