Legend Neo Angle Shower Enclosure Installation Instructions (400 Series) PATENTS PENDING 1 Legend Neo (No Latch) 04/18/2019
LEGEND NEO ANGLE SHOWER ENCLOSURE KEY LETTER A PART NUMBER 401 DESCRIPTION WALL JAMB B b1 b2 b3 b4 b5 ---235 404 407 6112PHS C 154 B SIDE PANEL ASSEMBLIES SIDE PANEL RAILS SIDE PANEL EXPANDER SIDE PANEL CORNER POST SIDE PANEL ASSEMBLY SCREW (not shown) SIDE PANEL GLAZING VINYL (not shown) 2 4 2 2 8 -- C c1 c2 c3 c4 c5 c6 c7 c8 c9 c10 c11 c12 c13 c14 c15 ---440 441 441 227 429 226 CP201 CP209 FW 10-093 98-42 C 176 B 634PHS 5112FHSL 5112FHSL C 173 B DOOR FRAME ASSEMBLY DOOR FRAME HEADER / SILL DOOR
STEP 1 Positioning Wall Jambs Determine the curb centerline, then offset and mark a line 3/8 of an inch toward the outside of shower as shown in figure 1. Separate the Wall Jambs (A) from their respective End Panels (B) as shown in exploded view. Place Wall Jambs (A) up against shower walls . . . aligning their outside legs with the offset mark previously marked on base ledge. Use a level to plumb Wall Jambs (A).
STEP 4 Door Frame Installation STEP 5 Bend, Brace and Install Header Bend the Header into shape as shown in step 6. Now brace the Header by pressing the braces (J) onto the header corners as shown. Install the Header over the unit and secure to unit using four self drilling screws (G), see explode view - sht 2. Trimming of Header may be required, if so, trim ends as required. STEP 6 Caulk for a leak proof installation Fig. 5a Place the Door Assembly (C) between the Panel Assemblies (B) as shown.
