Installation Guide

Step-4
The rubber ends are used to protect the door from touching the rail when sliding the door.
You need to drill holes on the door top side, please drill the holes 1/2” away from the edge
of the door. Then install the rubber ends on the door.
Step-5
/”
Insert door stoppers into rail. Install door stoppers between A-B and C-D
Door stopper is used to prevent the hangers coming out of the rail.
Step-3
A B C D
Do not screw it in
place at this stage
1/”
3/”
Install the hangers onto the door according to the measurement in the pictures below.
Maximum door thickness is 1/”. .
If your door’s thickness is less than 1/”, please add some bolt washers or cut the long door
bolts to a suitable length to fit the door. Install the hangers onto the door according to the mea-
surement in the pictures below .
10