Product Manual

Page 30
No.
Action
Image guided instruction
11.
When testing is complete,
the Pass/Fail results are
displayed in PT units.
Date and Time is also
displayed.
Note: Control test results only
display PT seconds, this is to avoid
confusing control strip INR results
with patient test strip INR results.
12.
Repeat Steps 3-12 using
the ‘High control strip.’
13.
Once the controls have
been successfully tested,
remember to remove and
discard the control strips.
You can now proceed to
testing blood samples. If
you are not going to test,
turn off the meter by
pressing and holding the
POWER button. The
opened control activation
solution may be used until
the expiration date.
Note: If control test fails, repeat the test with a new strip. If the control test
continues to FAIL, contact Coag-Sense Technical Support for assistance.